Junger-audio D*AP8 Digital Audio Processor Instrukcja Użytkownika Pobierz pdf (Strona 32)

100

D*AP8

Setup GUI – INTERFACES – SDI I/O interface – Embedder

Audio Embedder Here you set the general

functions of the embedder

Delete Existing Data [ALL – New HANC Structure

/ OFF]

Group 1 – 4 Mode [OFF / AUTO – Embedding

/ AUTO – Replace Audio

/ Delete]

See SDI I/O Interface > Overview

For details

AES Channel [Transparent / Professional]

Status In case of Professional these

values are used:

Format : Professional

Audio Mode : [Audio / Non

Audio]

Emphasis : None

Freq. Mode : Locked

Sample Freq. : 48kHz

Channel Mode : Not Indicated

User Bits : None

Auxiliary Bits : 24Bit

Audio Word

Length : Not indicated

Important note! If you generate a new AES channel

status the Audio Mode will be automatically set to Non

Audio (AKA "other") for both channels, if an adjacent pair

(1/2, 3/4 …..) carries a Dolby E stream for example.

VANC Metadata The embedder can insert one

Embedder Dolby metadata stream into the

Vertical Ancillary Data

Enable [ON / OFF]

Delete Existing [AII / OFF]

Metadata

Stream Select [SDID 1 … SDID 9]

(SDID)

Video Line [Auto / 9 … 44]

The line number depends on the actual video standard 8how many VAN

lines are available for data insertion.

Embedder Audio Each embedder signal may be delayed independently. This may be useful

Delay for Lips Sync alignment if a video delay is used.

Important Note! You must take care that for Dolby encoded signals the adjacent pairs must be set to the

same delay values not to destroy the data structure.

SDI OUT G1 CH1 (ms) [0.0000 … 340.000]

SDI OUT G4 CH16 (ms) [0.0000 … 340.000]

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 99 100

Komentarze do niniejszej Instrukcji

Brak uwag

Junger-audio D*AP8 Digital Audio Processor Instrukcja Użytkownika Strona 32

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Audio Junger-audio D*AP8 Digital Audio Processor